Super Core 1645 Watt PMA PMG 48 VOLT DC 2-Wire Wind Turbine Permanent Magnet

Description

Wind turbines generators sustainable 403 energy wind generaters mills wind mill generator power lakota wind power airx generation Wind turbines wind mills wind power wind power generation
This auction is for a SUPER-CORE (SC)  48
VDC 2-wire
PMA
#SC48DC
designed
for use with our 34.64" KT propeller (blades)  and with these
blades can make up to 1645 Watts peak power in high winds (Rated as peak)
All voltage ranges (VR) are based on use for battery charging with wind power!
This PMA's is recommended for wind turbines only! Peak at about 2000 RPM.
Freedom Verses Supercore PMA/PMG
(3 PHASE AC COIL ON THE INSIDE AND DC CONNECTIONS ON THE OUTSIDE)
For PMA's / PMG's  for engines / hydro use our line of #PC1212 or #QC1212 models.
SEE POWER CHART BELOW FOR ALL V.R. MODELS
1685 Watts peak / See peak volts for all models below* Make sure your equipment can handle these peaks.
Designed to operate in an area with low/medium speed averages of 4.4 to 5.6 m/s and greater (Zone 3-4)
Provides 189 kWh per month (2299kWh year)  6.3 kWh per day in a 12.7 mph (5.6 m/s) average wind speed.
In a zone 7 area this turbine can make up to 200% more power or 12.60 kWh.
Wind Zones are defined by m/s
Wind Zone 1      0 – 4.4 m/s
Wind Zone 2    4.4 – 5.1 m/s
Wind Zone 3    5.1 – 5.6 m/s
Wind Zone 4    5.6 – 6.0 m/s
Wind Zone 5    6.0 – 6.4 m/s
Wind Zone 6    6.4 – 7.0 m/s
Wind Zone 7    7.0 – 9.4 m/s  (20-22 mph)
*68v   12V  (for 12 volt model)
134v   24V  (for 24 volt model)
265v   48V  (for 48 volt model)
You will receive only the most modern magnet core with deep saturation slotted magnets providing deep reaching pole power into the stator coil for maximum amperage.
Includes a real original  SUPER-CORE PMA -
The reason why they cost less
is that they are utilizing an old fashioned
The modern type PLATE AND GROOVE rotor that we have developed is the most celebrated and also the most copied type which we pioneered.  The important part is that PLATE AND GROOVE makes power at MUCH LOWER RPM's than the older and traditional Clam type rotor designs that do not provide deep magnetic saturation of the Stator coil offering 600% more power in low RPM scenarios over Clam type designs
In small wind turbines this is VERY important to make your power in the LOWER RPM ranges.
Spend a little more and get a LOT more  BANG-FOR-YOUR-BUCK!!!  Money well spent!
From the beginning GM designed the Delco to run
WET and even tested them to operate
Under Water
!
Designing an alternator that can survive at 375 degrees F. under the hood of a car operating with rain water coming through the
radiator and from water puddles is
No Easy Task!
Over 100,000,000 10/12si's were produced by Delco and after-market vendors!
Parts for this legendary 'work-horse' will be available for the next 50+ years.  World's most supported and well recognized model!
Our Magnets are on an
angle
We make our own brand new
ROTOR POLE
SHOES
AND
STATOR CORES
!!!
Our PMA's are built from the ground up using only 100% ALL new parts!
(Including the rotor pole shoes and stator coil stacks)
Our
NEW
rotor poles are balanced to within .002 grams for SMOOOOOTH rotation!
Get the original -
MADE IN THE USA!
SUPER-Core PLUS+ Design.
Featuring 14 magnetic poles for achieving an amazing 35% power level increase!
Our Magnets are on an
angle
to prevent cogging!
By Hornet Power Systems
Use these powerful permanent magnet alternators (PMA's) to make cheap electricity with wind turbines
Stop wasting up to 50% of your power energizing the
coil of standard brush type alternators. Get a real PMA!
Permanent magnet alternators are by no means standard "Automotive" alternators containing brushes and electro-magnetic coils. A PMA does not waste power by having to continuously create an energy intensive magnetic field.
We sell only highly efficient - long lasting true permanent magnet alternators!
"The SC series PMA' are the most versatile PMA's we have ever built"