DIGITAL 12V Charge Controller W RECTIFIER Wind Turbine PMA, Made in USA

Description

DESIGN FEATURES:
Can be used for
wind or solar
power.
12VDC 150A continuous / 300 Amp
in rush current rating.
Display shows current battery voltage
in addition to any other user changeable settings.
Protect your battery
by using this to dump / divert your excess power.
Excess power can be diverted to a useful device such as a water heater, space heater, etc. or it can be dissipated with dump load resistors.
Components are mounted on a
3/16" non-conductive plate
and
pre-wired
.
Includes 50 Amp 3 phase AC to DC rectifier.
This charge controller has
multiple user adjustable settings
including dump point voltage level, end of dump voltage level and length of time in divert mode when dump point voltage is reached.
All control electronics are isolated
from high current loads.
The charge controller uses a high current mechanical solenoid relay that can handle high voltage surges unlike solid state controllers.
The non-conductive plate is
made in America
and designed specifically for this controller.  The mounting holes are 1/4" dia.  Measures 7-1/2" high x 5-1/2" wide.
The charge controller operates on 12VDC, but it
can
be used to control a
24- or 48-volt
battery bank if only one battery is sampled.  This configuration is not recommended, but it will work if needed.
SPECIFICATIONS:
VOLTAGE REQUIREMENT
:
12VDC (see note above regarding 24 and 48 volt battery banks)
MAXIMUM CURRENT RATING: 150A CONTINUOUS / 300A SURGE
DIMENSIONS: 7-1/2"H X 5.5"W X 3.25" THK