5/8 WIND TURBINE GENERATOR HUB ARBOR STAINLESS STEEL

Description

Windy Nation Inc. Precision Machined Wind Generator Arbor
100% Stainless Steel Construction
This is a new wind generator arbor which will allow you to attach your hub and blades to the shaft of your wind generator. It is machined on a computer controlled lathe to exact tolerances using 304 stainless steel. This will attach to any motor/generator shaft that is 5/8 inch in diameter.
The advantage of this arbor compared to many others on ebay is that it will not rust. If you buy any type of steel arbor (with the exception of stainless steel) it will rust away fairly quickly. Not only is this a waste of your money, it is dangerous! Why settle for an inferior arbor when you can grab this one at a very reasonable price!
Included In This Listing Is The following:
5/8 inch diameter arbor. The arbor will fit any motor or generator shaft that is 5/8 inch in diameter. The threaded portion of the arbor is 1/2 inch diameter and threaded at 13 TPI (threads per inch). This means you can attach a hub that has a 1/2 inch diameter mounting hole.
A stainless steel nut + stainless steel lock washer. This allows you to securely attach a hub to the arbor.
Three stainless steel set screws which allow you to securely attach the arbor to the shaft of the motor or generator. Three set screws spaced 120 degrees apart allow for a perfectly balanced arbor. This keeps your rotor spinning smooth and balanced even at very high rpm's.
Free shipping with the purchase of any Windy Nation blade set!
Look at the photo below to check out our 100% stainless steel arbor. Note that two arbors are shown in the picture so you can see the arbor assembled and unassembled. (Only one arbor is included with your purchase.)