4X Morimoto HD Load Resistors Dual Resistor 40W 7.5 ohms per resistor (4 QTY)

Description

Product Details
In Comparison:
The
Morimoto
Heavy Duty Load Resistors may do the same thing as a cheap golden resistor you can buy for a fraction of the price, but they'll stay much cooler, keep you much safer, last way longer, and look much better doing it!
You got it!
A top notch retrofit, a set of expensive LED bulbs, etc....why skimp out on the resistors that are sometimes required to keep your car happy while running them? Don't be "that guy" with an expensive set of LED headlights relying on a .99 craptastic resistor to keep em running.
Notorious:
As a component that's notorious for getting extremely hot when in use, it's not only careless to use a cheaply made automotive load resistor, it's dangerous. Not to mention the fact that the guys selling you those cheapo ones recommend mounting them with double-sided tape. What? that's going to fall off the first time the thing heats up. These MUST be mounted to a metal surface, with screws. Period....and that's why the Morimoto's have integrated mounting points.
What's Inside:
The extruded aluminum housing doubles as a heat-sink and outer shell for the resistor. To maximize heat-transfer, that's all one piece. On each end, 14 gauge wiring exits through ceramic ports to prevent anything from coming into contact with any heated surfaces. Everything is properly shielded with additional heat-shrink and capped off with high-quality terminals. From end-to-end the Morimoto HD load resistors are worth their weight, no doubt about it.
Tech Specs
WATTAGE:
40W each
RESISTANCE:
7.5 ohms
INPUT:
9006 Male
OUTPUT:
Nickel-Plated Ring Terminal Type
WIRING:
14ga High-Temp
SHELL MATERIAL:
Extruded Aluminum
FINISH:
Anodized/Laser Engraved
Compatibility
LED HyperFlash:
Yes
What's Included
RESISTOR:
4X Morimoto HD Load Resistor
WARMING: resistor gets hot when it is charging. please place or mount it to the metal surface to avoid over-heating. we are not responsible for any damage by using this product
this item can be use as load resistor to eliminate the hyper-flash when LED is installed on the vehicle. simply, just separate this dual resistor and T-tap the red wire to positive and black wire to negative of the blinker wires. please only use one resistor on each LED install.