2400 Watts Max-Core PMA 48 VAC 3-Phase Wind Turbine Permanent Magnet Generator

Description

2400 Watt peak Max-Core PMA 48 VAC 3-phase
PMA designed our 34.64" KT propeller (blades)  and with these blades can make up to 2400 Watts peak power in high winds (Rated as peak). All voltage ranges (VR) are based on use for battery charging with wind power!  This PMA's is recommended for wind turbines only! Peak at about 2000 RPM.
Thermodyne 1600W Wind Turbine Review
Video will open in a new window
Using the iPhone app? Copy this link into Safari:
TREX blades on SC12 PMA Wind Turbine windgeneering
Video will open in a new window
Using the iPhone app? Copy this link into Safari:
What's better, AC or DC wind turbine PMA's / PMG's
Video will open in a new window
Using the iPhone app? Copy this link into Safari:
Thermodnye Hornet Wind Farm
Video will open in a new window
Using the iPhone app? Copy this link into Safari:
2400 Watts peak / 2285 RPM at peak load.
For battery charging be sure to buy one of our "battery regulators"
Designed to operate in an area with low/medium speed averages of 4.3 to 5.6 m/s and greater (Zone 3-4).
Provides 303 kWh per month (3640kWh year)  8.8 kWh per day in a 12.4 mph (5.6 m/s) average wind speed.
In a zone 7 area this turbine can make up to 200% more power or 17.6 kWh.
Wind Zones are defined by m/s
Wind Zone 1      0 – 4.4 m/s  (Wind not recommended, go solar in this wind zone)
Wind Zone 2    4.4 – 5.1 m/s
Wind Zone 3    5.1 – 5.6 m/s
Wind Zone 4    5.6 – 6.0 m/s
Wind Zone 5    6.0 – 6.4 m/s
Wind Zone 6    6.4 – 7.0 m/s
Wind Zone 7    7.0 – 9.4 m/s  (20-22 mph)
Make sure your equipment can handle  the peak voltages of each model.
Batteries are good at absorbing high voltages as long as they do not go over
their voltage limits and that is why are battery regulators are critical to match
with our turbines.  We sell many models so make sure the voltages match your battery.
<
If you win this auction
you will get a -
MAX-CORE ROTOR +n50
EASY TURNING PMA
You will receive only the most modern magnet core with deep saturation slotted magnets providing deep reaching pole power into the stator coil for maximum amperage.
There are plenty of "Look-A-Like" PMA's on the market that cost less.
The reason why they cost less is that they are utilizing an old fashioned
The modern type PLATE AND GROOVE rotor that
Our Magnets are on an
angle for easy turning
Our PMA's are built from the ground up
using only 100% ALL new parts!
(Including the rotor pole shoes and stator coil stacks)
Our
NEW
rotor poles are balanced to
within .002 grams for SMOOOOOTH rotation!
MADE IN THE USA!
Not a cheap import or copy.
Get the original
SUPER-Core PLUS+ n50 Design.
Our NON-COGGING  PMA's have fantastic
low speed start up!
Featuring 14 n50 magnets for achieving
an amazing 38% power level increase!
By Hornet Power Systems
Use these powerful permanent magnet alternators (PMA's) to make cheap electricity with wind turbines
Stop wasting up to 50% of your power energizing the
coil of standard brush type alternators. Get a real PMA!
Permanent magnet alternators are by no means standard "Automotive" alternators containing brushes and electro-magnetic coils. A PMA does not waste power by having to continuously create an energy intensive magnetic field.
We sell only highly efficient - long lasting true permanent magnet alternators!
LOTS OF LOW END POWER GENERATION ABILITY!!!!
Perfect for building simple, inexpensive and dependable wind turbines.
A put-up and forget design! Expect decades of dependable service life.
Bi-rotational. Makes power when turned in either direction.
Note: Clockwise is the preferred direction since the nut tends to stay on and it cools better!
All weather rated. Rain, ice and weather proof electronics.
17MM hardened shaft.
Max-core 1.26" wide coil.
Heavy Duty coils and diodes.
Light weight aluminum body.
100% biassed magnetic field spread.
Powerful
#50H Neodymium magnets in rotor.
MAX-CORE series PMA's weigh 13 LBS. - Size 8" X 7" X 7"
WARNING!! Make sure you connect a PMA to the correct battery polarity. Positive PMA to positive battery terminal and negative PMA to negative battery terminal. IF you reverse the connections you will burn out your PMA as the power rushes past the blocking diodes and melts your coils!
TECH NOTES: (DC model shown)
Taking apart a PMA the right way.
1. Remove the 4 housing bolts and pull the front housing off OVER the shaft. Never pull the rear housing off first!!!!
If it is jammed or rusted use some WD-40 on the shaft and alternately tap the mounting wings with a hammer while applying pressure to the shaft with your thumb so that the stator and it's delicate wiring harness is kept in place. NOTE: If the shaft is scored-up badly you may have to sand the shaft down to it's original 17mm size to get the front housing off.
2. Now grab the exposed rotor core shaft and pull it out WHILE holding down the stator ring with your index
finger and thumb. This will take LOTS of strength!!!!! If you fail to hold the stator in place the core and stator
will be extracted together and the wires will be torn off of the stator and this is unrepairable! This is a tricky maneuver and usually takes some experience and lots of muscle!!!!!!!
3. Once the rotor core has been successfully extracted the rectifier connections are exposed and you may now unfasten the three wire nuts to safely remove the stator coil. (To reassemble simply reverse procedure)<"https://hydrogenappliances.com/12si_draft.jpg" target="_blank">
Warranties will be void on any PMA that is opened by a customer.
Any PMA experimentation and examination is at your own risk.
CLICK DRAWING TO ENLARGE
WARNING; High voltage PMA's and battery banks can cause lethal electric shock!
PLEASE NOTE: Our model numbers have nothing to do with voltages, they are just model numbers.
Notes From Happy Customers
Dear qaz661,
I just want to brag about your blades and PMA, I live here on a mountain
top in Idaho, and had freezing temps. Then came the high winds, the 12 volt
PMA maxed out over 75 volts and the blades held together with wind gusts
over 50 MPH. What a great product. I just need a controller that won't
smoke with these high wind surges, what do you recommend?
Thanks Sonny
-ljdk07
eBay Member: brianrlee wrote:
You guys are great. By the way I'm very impressed with the scs24 pma
it seems to be out preforming the power curve in the ebay ad by quite a bit.
Thanks again, Brian
Froo www.froo.com | Froo Cross Sell, Free Cross Sell, Cross promote, eBay Marketing, eBay listing Apps, eBay Apps, eBay Application