2400 Watt MAX-CORE MC PMA 24 VAC 3 PHASE Wind Turbine Permanent Generator

Description

This auction is for a
MAX-CORE 24 Volt AC 3-Phase
model.  New Model comes with new heavy internal coil so bulk of coil is on the inside of PMA shell for
compact
design.  Designed
for use with our 34.64" KT propeller (blades)  and with these blades can make up to 2400 Watts peak power in high winds (Rated as peak)  This PMA's is recommended for wind turbines only! Peak at about 2000 RPM.
Comes with thin-set spacer kit.
POWER:
2400 Watts peak / 2285 RPM at peak load.
For battery charging be sure to buy one of our "battery regulators"
Designed to operate in an area with low/medium speed averages of 4.3 to 5.6 m/s and greater (Zone 3-4)
Provides 303 kWh per month (3640kWh year)  8.8 kWh per day in a 12.4 mph (5.6 m/s) average wind speed.
In a zone 7 area this turbine can make up to 200% more power or 17.6 kWh.
Wind Zones are defined by m/s
Wind Zone 1      0 – 4.4 m/s
(Wind not recommended, go solar in this wind zone)
Wind Zone 2    4.4 – 5.1 m/s
Wind Zone 3    5.1 – 5.6 m/s
Wind Zone 4    5.6 – 6.0 m/s
Wind Zone 5    6.0 – 6.4 m/s
Wind Zone 6    6.4 – 7.0 m/s
Wind Zone 7    7.0 – 9.4 m/s  (20-22 mph)
Make sure your equipment can handle  the peak voltages of each model.
Batteries are good at absorbing high voltages as long as they do not go over.
their voltage limits and that is why are battery regulators are critical to match
with our turbines.  We sell many models as long as the voltages match.
Thermodyne 1600W Wind Turbine Review
Video will open in a new window
Using the iPhone app? Copy this link into Safari:
TREX blades on SC12 PMA Wind Turbine windgeneering
Video will open in a new window
Using the iPhone app? Copy this link into Safari:
What's better, AC or DC wind turbine PMA's / PMG's
Video will open in a new window
Using the iPhone app? Copy this link into Safari:
Thermodnye Hornet Wind Farm
Video will open in a new window
Using the iPhone app? Copy this link into Safari:
You will receive only the most modern magnet core with deep saturation slotted magnets providing deep reaching pole power into the stator coil for maximum amperage.
Includes a real original
MAX-CORE PMA -
The reason why they cost less is that they are utilizing an old fashioned
The modern type PLATE AND GROOVE rotor that we have developed is the most celebrated and also the most copied type which we pioneered.  The important part is that PLATE AND GROOVE makes power at MUCH LOWER RPM's than the older and traditional Clam type rotor designs that do not provide deep magnetic saturation of the Stator coil offering 600% more power in low RPM scenarios over Clam type designs
In small wind turbines this is VERY important to make your power in the LOWER RPM ranges.
Spend a little more and get a LOT more  BANG-FOR-YOUR-BUCK!!!  Money well spent!
From the beginning GM designed the Delco to run
WET and even tested them to operate
Under Water
!
Our Magnets are on an
angle to buffer-out any cogging
Our
NEW
rotor poles are balanced to within .002 grams for SMOOOOOTH rotation!
Our PMA's are built from the ground up using only 100% ALL new parts!
(Including the rotor pole shoes and stator coil stacks)
MADE IN THE USA!
Featuring 14 magnetic poles for achieving
an amazing 35% power level increase!
Our Magnets are on an
angle
to prevent cogging!